TM-5-5420-202-20-3
M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4
OCTOBER 1985
TM-5-5420-202-20-3 - Page 481 of 1060
TM 5-5420-202-20-3
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR (Sheet 13 of 18)
Female Plug Repair (Sheet 3 of 3)
14. Using remover, push contact (E) into
plug assembly (B).
11.
12.
Hold jumper wire so wire end is pushing
down on solder in contact solder well (F).
Holding soldering gun tip against side of
contact (E) until solder begins to melt
and wire slips into contact solder well (F).
13.
15.
16.
17.
Using multimeter, check continuity of
repaired circuit.
18.
Tighten or install cable clamps as required.
19.
Connect connectors at each end of
affected cable.
20.
Connect three battery ground straps (page
10-268).
End of Task
Removing soldering gun from side of
contact (E), continue holding wire until
solder has cooled and set.
Sliding grommet (D) forward along cable
(C), set grommet (D) firmly against
contacts (E).
Manually thread grommet retaining nut (A)
onto plug assembly (B).
TA249251
10-310
Back to Top
