TM-5-5420-202-20-3
M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4
OCTOBER 1985
TM-5-5420-202-20-3 - Page 478 of 1060
TM 5-5420-202-20-3
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR (Sheet 10 of 18)
Female Plug Repair (Sheet 3 of 3)
11.
12.
13.
15.
16.
17.
18.
19.
20.
Hold soldering gun tip against side of
contact (E) until solder begins to melt
and wire slips into contact solder well (F).
Removing soldering gun from side of
contact (E), continue holding wire until
solder has cooled and set.
Hold jumper wire so wire end is pushing
down on
solder in contact solder well (F).
Sliding grommet (D) forward along cable
(C), set grommet (D) firmly against
contacts (E).
14.
Using remover, push contact (E)
into plug assembly (B).
Manually thread grommet retaining nut (A)
onto plug assembly (B).
Using multimeter, check continuity of repaired circuit.
Tighten or install cable clamps as required.
Connect connectors at each end of affected cable.
Connect three battery ground straps (page 10-268).
End of Task
TA249248
10-307
Back to Top
