TM-5-5420-202-20-3
M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4
OCTOBER 1985
TM-5-5420-202-20-3 - Page 485 of 1060
TM 5-5420-202-20-3
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR (Sheet 17 of 18)
Female Receptacle Repair (Sheet 2 of 3)
9.
10.
Push new contact (E) into hole in back of
plug assembly (B) far enough so it will
remain standing.
Push jumper wire end, first through
grommet retaining nut (A) and then
through hole in grommet (D).
7.
Using hand wire stripper, strip insulation
from jumper wire equal to depth of contact
solder well (F).
8.
Placing connector face down on flat
surface, apply a small amount of silicone
to empty holes on back of plug assembly
(B) and on front of grommet (D).
11.
12.
13.
Hold jumper wire so wire end is pushing
down into solder in contact solder well (F).
Hold soldering gun tip against side of
contact (E) until solder begins to welt
and wire slips into contact solder well (F).
Removing soldering gun from side of contact
(E), continue holding wire until solder has
cooled and set.
Go on to Sheet 3
TA249255
10-314
Back to Top
