TM-5-5420-202-20-3
M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4
OCTOBER 1985
TM-5-5420-202-20-3 - Page 477 of 1060
TM 5-5420-202-20-3
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR (Sheet 9 of 18)
Female Plug Repair (Sheet 2 of 3)
5.
6.
Using diagonal cutting pliers, cut wire
from contact (E). Throw away contact (E).
Pulling cut wire out of grommet (D), use
diagonal cutting pliers to shorten wire
about 6 inches. Fasten new end of cut wire
to cable (C) and wrap with friction tape.
7. Using hand wire stripper, strip insulation
from jumper wire equal to depth of contact
solder well (F).
8.
Placing connector face down on flat
surface, apply a small amount of silicone
to empty holes on back of plug assembly
(B) and on front of grommet (D).
9.
Push new contact (E) into hole in back of
plug assembly (B) far enough so it will
remain standing.
10.
Push jumper wire end, first through
grommet retaining nut (A) and then
through hole in grommet (D).
Go on to Sheet 3
10-306
TA249247
Back to Top
