TM-5-5420-202-20-3
M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4
OCTOBER 1985
TM-5-5420-202-20-3 - Page 480 of 1060
TM 5-5420-202-20-3
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR (Sheet 12 of 18)
Female Plug Repair (Sheet 2 of 3)
5.
6.
Using diagonal cutting pliers, cut
wire from contact (E). Throw away
contact (E).
Pulling cut wire out of grommet (D),
use diagonal cutting pliers to shorten
wire about 6 inches. Fasten new end
of cut wire to cable (C) and wrap
with friction tape.
Using hand wire stripper, strip insulation
from jumper wire equal to depth of contact
solder well (F).
Placing connector face down on flat
surface, apply a small amount of silicone
to empty holes on back of plug assembly
(B) and on front of grommet (D).
9.
10.
Push new contact
plug assembly (B)
remain standing.
Push jumper wire
(E) into hole in back of
far enough so it will
end, first through
TA249250
10-309
grommet retaining nut (A) and then
through hole in grommet (D).
Go on to Sheet 3
Back to Top
