TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 475 of 1060

TM 5-5420-202-20-3

ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR (Sheet 7 of 18)

Terminal Connector Repair (Sheet 2 of 2)

4. Slide new heat-shrink tubing (D)

onto and back along cable (C).

5. Slide new terminal (B) over stripped cable

end (E) and onto cable (C).

6. Using crimping tool, crimp terminal (B) at

(F) and (G).

7. Slide heat-shrink tubing (D)

over crimps (F and G).

8.

Using heat gun, shrink tubing (D).

9. Using multimeter, check continuity of

repaired circuit.

10. Tighten or install cable clamps as required.

11. Connect three battery ground straps (page 10-268).

End of Task

TA249245

10-304