TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 342 of 750

TM 5-5420-228-24

7.

8.

SCISSORS CYLINDER HOSE ASSEMBLIES (CF1, CF2, CG, CI, AND CJ) AND HYDRAULICS

REPLACEMENT (Sheet 7 of 12)

INSTALLATION:

NOTE

●

Remove all caps and plugs as necessary during installation. Before installa-

tion, use pipe tape on all male threads. Start tape on second thread so tape

will not enter hydraulic system.

●

Procedure for installation of right side components and left side compo-

nents is identical. Right side shown.

1.

Place handle (A) in position.

2.

Using hammer, tap pin (B) into position.

3.

Using long round nose pliers, install two

cotter pins (C) to secure. pin (B).

4.

Place spring retainer (D) into position.

5.

Using 3/8 inch socket, install screw (E) and lockwasher (F) securing spring retainer (D).

6.

Holding nipple (G) with pipe wrench, use 12

inch adjustable wrench to install elbow (H).

Manually install nipple (G) with elbow (H)

in position.

Manually install clamp (J) in position on

nipple (G).

TA251543

3-145

Go on to Sheet 8