TM-5-5420-228-24
LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL
AUGUST 1985
TM-5-5420-228-24 - Page 344 of 750
TM 5-5420-228-24
SCISSORS CYLINDER HOSE ASSEMBLIES (CF1, CF2, CG, CI, AND CJ) AND HYDRAULICS
REPLACEMENT (Sheet 9 of 12)
NOTE
Collar marked “CF1” goes on left side. Collar
marked “CF2” goes on right side.
18.
Holding elbow (H) with 12 inch adjustable
wrench, use other 12 inch adjustable wrench to
install elbow (V) and collar “CF2” (W).
19.
Holding elbow (V) with 12 inch adjustable
wrench, use other 12 inch adjustable wrench to
install elbow (X).
20.
21.
Repeat steps 1 through 19 for left side.
Holding elbow (X) with 12 inch adjustable
wrench, use 1-1/4 inch wrench to install
hose assemblies “CF2” (Y) on elbow (X).
Manually position relief valve “RV8” (P) and
attached parts between mounting brackets.
Manually install elbow (Z) and collar “CF2”
(AA), in relief valve (P).
Install adapter (AB) and collar “CJ” (AC)
in bushing (U).
Holding relief valve “RV8” (P) with 15 inch
adjustable wrench, use 12 inch adjustable
wrench to tighten elbow (Z).
22.
23.
24.
25.
inch wrench to tighten adapter (AB).
1-1/4 inch wrench to install hose
1-1/8 inch wrench to install adapter
26.
Holding bushing (U) with 1-3/8 inch wrench, use 1-1/8
Holding elbow (Z) with 12 inch adjustable wrench, use
assembly “CF2” (Y) on elbow (Z).
Holding elbow (Q) with 12 inch adjustable wrench, use
(AD) and collar “CG” (AE) onto elbow (Q).
27.
28.
Holding adapter (AD) with 1-1/8 inch wrench, use 1-1/4 inch wrench to install hose
assembly “CG” (AF) on adapter (AD).
29.
Go on to Sheet 10
TA251545
3-147
Back to Top
