TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 340 of 750

TM 5-5420-228-24

SCISSORS CYLINDER HOSE ASSEMBLIES (CF1, CF2, CG CI, AND CJ) AND HYDRAULICS

REPLACEMENT (Sheet 5 of 12)

25.

Using 9/16 inch socket, remove eight screws

(AJ) and lockwashers (AK).

26.

Remove boom mount hose armor (AL).

NOTE

Two upper hose assemblies are removed

in step 27, to provide clearance for removal

of “CJ” and “CI”.

27.

Holding two elbows (AM) with 12 inch

adjustable wrench, use 1-1/4 inch wrench to

remove hose assemblies (AN) and (AP) from

two elbows (AM).

28.

Holding two elbow assemblies (AQ) with 12

inch adjustable wrench, use 1-1/4 inch

wrench to remove hose assemblies “CJ” (V)

and “C1” (H) from elbows (AQ).

Using 12 inch adjustable wrench on two

29.

elbows (A Q), use 1-1/4 inch wrench to loosen

elbow nuts (AR).

30.

Using 12 inch adjustable wrench,

remove elbows (AQ), elbow nuts (AR),

flat washers (AS) and preformed pack-

ings (AT).

Throw away preformed

packings (AT).

NOTE

Procedure for removal of right side compo-

nents and left side components is identical.

Right side is shown.

31.

Holding elbow (AU) with 12 inch adjustable

wrench, use 12 inch adjustable wrench to

remove elbow (W) from elbow (AU).

32.

Holding elbow (AV) with 12 inch adjustable

wrench, use 12 inch adjustable wrench to

remove elbow (AU) and collar “CF2” (AW)

from elbow (AV).

Go on to Sheet 6

TA251541

3-143