TM-9-2320-209-34-2-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 3 OF 3

MAY 1981

TM-9-2320-209-34-2-3 - Page 276 of 592

TM 9-2320-209-34-2-3

FRAME 16

1.

Move shifter rod (1) until detent (2) in shifter fork (3) goes into rear winch

reverse position (4) in shifter shaft (5). Sliding gear (6) should mesh fully

with reverse idler gear (7) when input shaft (8) is turned.

2.

If sliding gear (6) does not mesh fully with reverse idler gear (7), move

shifter shaft (5) until gears are meshed fully.

3.

Check that sliding gear (6) does not mesh with other gears in neutral

position.

If gear does not mesh, go back to frame 15.

GO TO FRAME 17

18-265