TM-9-2320-209-34-2-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 3 OF 3

MAY 1981

TM-9-2320-209-34-2-3 - Page 277 of 592

TM 9-2320-209-34-2-3

FRAME 17

1.

Move shifter rod (1) until detent (2) in shifter fork (3) goes into rear winch forward

position (4) in shifter shaft (5).

Sliding gear (6) should mesh fully with forward speed

gear (7) when input shaft (8) is turned.

2.

If sliding gear (6) is not meshed fully with forward speed gear (7), move shifter

shaft (5) with screwdriver until it is.

3.

Check that sliding gear (6) does not mesh with any other gears in neutral

position.

Refer to frame 15.

4.

Check that sliding gear (6) meshes fully with reverse idler gear in the rear

winch reverse position.

If gear does not mesh fully, go back to frame 16.

GO TO FRAME 18

18-266