TM-9-2320-209-34-2-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 3 OF 3

MAY 1981

TM-9-2320-209-34-2-3 - Page 273 of 592

TM 9-2320-209-34-2-3

FRAME 13

1. If oil seal (1) was taken out of bearing cap (2), press in new seal. Make sure that

lip on seal faces inside bearing cap (2) and that seal casing is flush with outer end

of cap.

2. Put shims (3) on bearing cap (2) as noted.

3. Put bearing cap (2) with oil seal (1) and shims (3) on housing (4). Put in four

capscrews and washers (5).

4. Put bearing sleeve (6) on shaft (7) and seat it against bearing in housing (4).

5.

Put flange (8) on shaft (7). Put on nut (9) and washer (10).

GO TO FRAME 14

18-262