TM-9-2320-272-23-4
TRUCK, 5-TON, 6X6, M939, M939A1, AND M939A2 SERIES TRUCKS (DIESEL)
TECHNICAL MANUAL; FIELD MAINTENANCE MANUAL; VOLUME 4 OF 5
SEPTEMBER 2012
TM-9-2320-272-23-4 - Page 740 of 1393
SIDE ROLLER ASSEMBLY
1.
Install two grease fittings (Figure 5, Item 4) on shaft (Figure 5, Item 5).
2.
Install spacer (Figure 5, Item 13) on bracket (Figure 5, Item 3) with plate (Figure 5, Item 2), two lockwashers
(Figure 5, Item 14), and screws (Figure 5, Item 1).
3.
Pack two bearings (Figure 5, Item 11) with grease and install in roller (Figure 5, Item 12).
4.
Soak two felt washers (Figure 5, Item 10) in lubricating oil prior to installation. Position two felt washers and
thrust washers (Figure 5, Item 9) on each end of roller (Figure 5, Item 12).
NOTE
Assistant will help with Steps (5) and (6).
5.
Slide roller (Figure 5, Item 12), bearing (Figure 5, Item 11), felt washers (Figure 5, Item 10), and thrust washers
(Figure 5, Item 9) into bracket (Figure 5, Item 3).
6.
Install shaft (Figure 5, Item 5) through bracket (Figure 5, Item 3) and roller (Figure 5, Item 12). Make sure
locking slot is at bottom.
7.
Align lockplate (Figure 5, Item 8) with shaft (Figure 5, Item 5) and install with two lockwashers
(Figure
5,
Item
7) and screws (Figure 5, Item 6).
3
4
5
M9938DAA
1
2
4
6
7
8
9
10
11
12
11
10
9
13
14
Figure 5.
Rear Winch Roller Repair - Side Roller Assembly.
END OF TASK
TM 9-2320-272-23-4
0676
0676-7
Back to Top
