TM-9-2320-272-24-3
TRUCK, 5-TON, 6X6, M939, M939A1, AND M939A2 SERIES TRUCKS (DIESEL)
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL; VOLUME 3 OF 4
JUNE 1998
TM-9-2320-272-24-3 - Page 690 of 799
4-205. TRANSFER
TM 9-2320-272-24-3
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
M936/A1
TM 9-2320-272-10
TOOK
General mechanic’s tool kit (Appendix E, Item 1)
MATERIALS/PARTS
TM 9-2320-272-24P
EQUIPMENT CONDITION
Parking brake set (TM 9-2320-272-10).
Two locknuts (Appendix D, Item 291)
Locknut (Appendix D, Item 299)
Two locknuts (Appendix D, Item 313)
Cotter pin (Appendix D, Item 70)
Tiedown straps (Appendix D, Item 689)
1.
Remove tiedown straps from Power Takeoff (PTO) cable (4) as required. Discard tiedown straps.
2.
Remove cotter pin (10), clevis pin (2), and PTO cable clevis (3) from PTO select lever (1). Discard
cotter pin (10).
3.
Remove two locknuts (9), screws (6), clamp (5), PTO cable (4), and shim (7) from PTO cable
bracket (8). Discard locknuts (9).
4.
Remove PTC clevis (3) from PTO cable (4).
5.
Remove two locknuts (14), screws (11), clamp (15), PTO cable (4), and shim (13) from PTO cable
bracket (12). Discard locknuts (14).
6.
Remove locknut (19) and PTO cable swivel bolt (17) from select lever (18). Discard locknut (19).
7.
Remove swivel bolt (17) and cable clevis (16) from PTO cable (4).
1.
Install swivel bolt (17) and cable end (16) on PTO cable (4).
2.
Install PTO cable swivel bolt (17) on select lever (18) with new locknut (19).
3.
Install shim (13), PTO cable (4), and clamp (15) on PTO cable bracket (12) with two screws (11) and
new locknuts (14).
4.
Install PTO clevis (3) on PTO cable (4).
5.
Install shim (7), PTO cable (4), and clamp (5) on PTO cable bracket (8) with two screws (6) and
new locknuts (9).
NOTE
Transfer case PTO cable can be adjusted at two points.
Adjustments can be made at transfer case select lever cable clevis
or transfer case PTO select lever cable collar.
6.
Adjust PTO cable clevis (16) forward until aligned with transfer PTO select lever (18). If necessary,
reposition transfer PTO cable (4) at PTO cable collar at cross-shaft end of cable (4).
7.
Install PTO clevis (3) on PTO select lever (1) with clevis pin (2) and new cotter pin (10).
8.
Install tiedown straps on PTO cable (4) as required.
4-954
Back to Top
