TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 492 of 801

TM 9-2320-273-34

Driving carrier into housing with a steel

hammer will damage carrier flange and

cause severe oil leakage.

(2)

Roll the carrier into position on a roller jack. Start the carrier into the housing with four

flat washers and capscrews equally spaced. Tighten alternately to draw the carrier squarely into the axle

housing.

(3)

After the drive unit has been drawn up tightly to the housing, install the balance of

washers and capscrews. Torque capscrews to 180-230 Ib-ft (244-312 N•m).

(4)

Install right and left axles with new gaskets (fig. 11-4). Secure with tapered dowels,

washers, and nuts. Torque nuts to 175 Ib-ft (237 N•m).

11-11. Output Shaft Assembly.

a.

Coat bearings with recommended axle lubricant (item 30, App B) and press both inner and outer

bearing cones (back-to-back) onto end of output shaft until inner bearing cone bottoms on the shaft

shoulder (fig. 11-50). Use a press and suitable sleeve.

Figure 11-50. Assemble Output Shaft and Yoke.

11-46

CAUTION