TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 488 of 801

TM 9-2320-273-34

(8)

Assemble filter cover over filter on helical gear cover. Secure with two long oil pump

relief valve cover capscrews and washers. Torque to 20-30 Ib-ft (27-41 N•m).

m. Assemble and Install Input Shaft Yoke

Do not drive yoke onto shaft by

pounding or tapping.

(1)

Coat yoke seal elements with gear lube. Also ensure that there are no burrs or nicks on

the yoke wiper surface or on any surfaces that will pass through the seal during installation.

(2)

Install slinger on input shaft (see fig. 11-2),

(3)

Thread the yoke installation shaft into pinion input, output or through-shaft until

installation shaft bottoms (fig. 11-47).

Figure 11-47. Install Yoke with Installation Tool.

(4)

Slide the yoke over the installation shaft, alining yoke and shaft splines of drive unit.

(5)

Place installation collar over the installation shaft, against yoke.

(6)

Thread nut onto installation shaft, against the collar. Continue threading the nut against

collar until yoke seats against bearing. A torque value of 200 Ib-ft (270 N•m) on nut may be required to

properly install and seat yoke.

11-42

CAUTION