TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 489 of 801

TM 9-2320-273-34

Do not use a prevailing torque nut to

install the yoke, as damage to the threads

will result. Use only the nut furnished

with tool.

(7)

Remove all parts of the installation tool from the drive unit.

(8)

Install washer and nut. Tighten nut to 450-600 Ib-ft (610-813 N•m).

n. Assemble the Helical Gear Cover onto Carrier.

(1)

Before assembling the cover to carrier, coat the forward interaxle differential side gear

thrust washer and backface of integral shift collar gear (on input shaft) with grease.

(2) Place the thrust washer onto the back face of shift collar gear. The grease will allow the

washer to stick to the gear.

Do not assemble the thrust washer onto the

forward side gear in carrier. Damage to the

washer will occur if the slightest misaline-

ment is present.

(3)

Apply silicone gasket materiel to the mating surfaces of the two cases.

(4)

carrier.

Using a hoist attached to the input yoke (fig. 11-48), position the gear cover above the

11-43

Figure 11-48. Install Cover on Carrier.

CAUTION

CAUTION