TM-9-2320-283-13-P

ANTI-LOCK BRAKE SYSTEM (ABS) M915A1

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)

AUGUST 2012

TM-9-2320-283-13-P - Page 233 of 400

TM 9-2320-283-13&P

0030

0030-3

REMOVAL – CONTINUED

1

2

3

4

5

Figure 3. Checking ABS ECU 5-amp Fuse.

END OF TASK

INSTALLATION

CAUTION

Never replace original fuse with a higher amp fuse or use jumper

wire in place of fuse to complete circuit. Failure to comply may

result in damage to equipment.

1.

Install fuse (figure 3, item 3) on fuse connector (figure 3, item 5) and push cover

(figure 3, item 2) on fuse connector (figure 3, item 5).

2.

Position circuit breaker panel (figure 2, item 4) in place on dash panel (figure 2, item 9) and install star

washer (figure 2, item 3) and screw (figure 2, item 2) on dash panel

(figure 2, item 9) and circuit breaker panel (figure 2, item 4).

3.

From glove compartment (figure 2, item 8), install two star washers (figure 2, item 6) and screws

(figure 2, item 7) on dash panel (figure 2, item 9) and circuit breaker panel

(figure 2, item 4). Close and secure glove compartment door (figure 2, item 10).

4.

Close circuit breaker cover (figure 2, item 1) and turn three turnlock fasteners

(figure 2, item 5) 90 degrees.