TM-9-2320-328-13-P-2

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3

MARCH 2009

TM-9-2320-328-13-P-2 - Page 1283 of 1390

TM 9-2320-328-13&P-2

0310-3

DRAFT

0310

4.

Remove screw (9) and elbow (10) from pump house heater (8).

5.

With the aid of an assistant, remove two clamps (11) and pump house heater (8) from two brackets (12) and

vehicle.

NOTE

•

Perform Step (6) if brackets need to be removed.

•

Note position of brackets prior to removal to ensure proper installation.

6.

Remove four nuts (13), lockwashers (14), eight washers (15), four screws (16), and two brackets (10) from

vehicle.

Discard lockwashers.

END OF TASK

INSTALLATION

NOTE

•

Perform Step (1) if brackets were removed.

•

Install brackets as noted prior to removal.

1.

Install two brackets (10) on vehicle with four screws (16), eight washers (15), four lockwashers (14), and

nuts (13).

2.

With the aid of an assistant, install pump house heater (8) on two brackets (12) with two clamps (11).

3.

Install elbow (10) on pump house heater (8) with screw (9).

4.

Install exhaust tube (7) on pump house heater (8) and tighten clamp (6).

5.

Connect three pump house wire harness connectors (5) to three pump house heater wire harness

connectors (4).

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

- -

-

-

-

-

-

-

-

-

-

-