TM-9-2320-328-13-P-2

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3

MARCH 2009

TM-9-2320-328-13-P-2 - Page 388 of 1390

TM 9-2320-328-13&P-2

0145-2

DRAFT

0145

FILL

1.

Remove hydraulic reservoir breather (5) from hydraulic reservoir (4).

2.

Fill hydraulic reservoir (4) until indicator (6) on fluid level gauge (7) reaches mark on full cold.

3.

Install hydraulic reservoir breather (5) on hydraulic reservoir (4).

NOTE

Perform Steps (4) through (9) if any hydraulic components have been removed or

replaced.

4.

Connect batteries (TM 9-2320-325-14&P).

5.

Start engine (TM 9-2320-422-10).

6.

Operate PTO for one minute (WP 0004).

7.

Disconnect batteries (TM 9-2320-325-14&P).

8.

Check for leaks.

9.

Check indicator (6) on fluid level gauge (7) and fill hydraulic reservoir (4) until indicator (6) on fluid level

gauge (7) reaches mark on full cold.

END OF TASK

FOLLOW-ON MAINTENANCE

1.

Close pump house panel K access door (WP 0008)

2.

Remove wheel chocks (TM 9-2320-422-10)

END OF TASK

END OF WORK PACKAGE

HWT1616