TM-9-2320-328-13-P-2

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3

MARCH 2009

TM-9-2320-328-13-P-2 - Page 399 of 1390

TM 9-2320-328-13&P-2

0148-7

DRAFT

0148

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

NOTE

Perform Steps (21) and (22) if brackets need to be removed.

21. Remove four nuts (55), lockwashers (56), eight washers (57), four screws (58), and bracket (37) from

crossmember (59) and support bracket (60).

Discard lockwashers.

22. Remove five nuts (61), lockwashers (62), ten washers (63), five screws (64), and bracket (32) from

crossmember (59) and support bracket (60).

Discard lockwashers.

END OF TASK

INSTALLATION

NOTE

Perform Steps (1) and (2) if brackets were removed.

1.

Install bracket (32) on support bracket (60) and crossmember (59) with five screws (64), ten washers (63), five

lockwashers (62), and nuts (61).

2.

Install bracket (37) on support bracket (60) and crossmember (59) with four screws (58), eight washers (57),

four lockwashers (56), and nuts (55).

3.

Lightly lubricate two seals (53) with clean oil, and install seal (53) on hydraulic reservoir (31) with two

retainers (54), covers (52), and tighten screws (51).

HWT2035