TM-9-2320-328-13-P-3

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 3 OF 3

MARCH 2009

TM-9-2320-328-13-P-3 - Page 163 of 844

TM 9-2320-328-13&P-3

0344-1

DRAFT

0344

Change 1

FIELD LEVEL MAINTENANCE

REAR HARD LIFT REPLACEMENT

INITIAL SETUP:

REMOVAL

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

NOTE

•

Perform Steps (1) through (4) to position end plate lift tubes in lift position.

•

Driver side and passenger side end plate tubes are installed the same way.

Driver side

shown.

1.

Remove lockpin (1) from rear hard lift assembly (2).

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

- -

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

HWT3431

Tools and Special Tools

Standard Automotive Tool Set (SATS),

(WP 0398, Item 15)

• Wrench, Torque, Click, Ratchet, 3/4” Drive,

600 ft-lb

Tool Kit, General Mechanic’s: Automotive

(WP 0398, Item 17)

Materials/Parts

Locknut (8)

Locknut (4)

Personnel Required

MOS 63B Wheeled Vehicle Mechanic (2)

References

WP 0391, Fig. 77

Equipment Conditions

Engine OFF (TM 9-2320-422-10)

Wheels chocked (TM 9-2320-422-10)