TM-9-2320-361-34

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

MAY 1992

TM-9-2320-361-34 - Page 177 of 764

TM 9-2320-361-34

7-3. FRONT WIRING HARNESS REPLACEMENT (Contd)

52. Disconnect wires (10) and (11) from stoplight switch (12).

53. Remove two nuts (14), screws (13), and front wiring harness (1) horn rear wiring harness (15) and

brace (16).

54. Remove two locknuts (2), screws (8), and clamps (3) from brace (4), front wiring harness (1), and

frame (9). Discard locknuts (2).

55. Remove nut (5) and clamp (7) from front wiring harness (1) and U-bolt (6).

CAUTION

●

Prior

to removal of wiring harness, ensure all clamps and

disconnections have been performed. Failure to do so may result in

damage to equipment.

●

Use care when removing front wiring harness. Snagging and

pulling may cause damage to harness.

56. Remove front wiring harness (1) from left side frame (17), fright side frame (18), over steering

column (19), and through firewell (21).

b. Installation

CAUTION

Use care when routing front wiring harness. Snagging and pulling

may cause damage to front wiring harness.

NOTE

●

If

new wiring harness is to be installed, remove tags from old

harness and install on new harness.

●

For additional wiring harness installation information, refer to

Electrical System Wiring Diagram (TM 9-2320-361-20).

1. Install front wiring harness (1) through firewall (21), left side frame (17), and right side frame (18),

over steering column (19), and under cab (20).

7-26