TM-9-2320-440-13-P

TERMINAL HIGH ALTITUDE AREA DEFENSE (THAAD) CARRIER

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2010

TM-9-2320-440-13-P - Page 1053 of 1616

TM 9-2320-440-13&P

0143-13

0143

WARNING

Adhesives, solvents, and sealing compounds can burn easily, can give off harmful

vapors, and are harmful to skin and clothing. To avoid injury or death, keep away

from open fire and use in a well-ventilated area. If adhesive, solvent, or sealing

compound gets on skin or clothing, wash immediately with soap and water.

CAUTION

Ensure same plate is installed on same side of inner beam. Each plate may be a

different thickness. Failure to comply may result in damage to equipment.

NOTE

One plate is installed on each side of inner beam. Both plates are installed the same way.

Rear plate shown.

13. Apply adhesive to four screws (21).

14. Install rear plate (22) on outrigger weldment (23) with four screws (21).

15. Repeat step (13) to install front plate.

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

WARNING

Outer beam weighs 152 lbs (69 kg). Do not lift outer beam without the aid of Soldier

B and a suitable lifting device. Failure to comply may result in serious injury to

personnel.

16. Attach a suitable lifting device to outer beam (8).

CAUTION

•

Do not scrape inner beam on extension cylinder rod when installing inner beam in

outrigger weldment. Failure to comply may result in damage to equipment.

•

Ensure hoses slide through guides inside outer beam when installing outer beam.

Failure to comply may result in damage to equipment.

17. Insert two hoses (9 and 11) in guides inside outer beam (8).

THAAD0107