TM-9-2320-440-13-P

TERMINAL HIGH ALTITUDE AREA DEFENSE (THAAD) CARRIER

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2010

TM-9-2320-440-13-P - Page 1097 of 1616

TM 9-2320-440-13&P

0154-1

0154

FIELD LEVEL MAINTENANCE

SUSPENSION BUSHING (EQUALIZING AND TRANSVERSE) REPLACEMENT

INITIAL SETUP:

EQUALIZING BEAM BUSHING REMOVAL

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

WARNING

Use of a press of 10,000 lbs (4,540 kg) capacity or greater is required to remove or

install bushings on equalizing beams.

Use care when pressing bushings to prevent

injury or death to personnel.

Always wear eye protection to prevent injury when

operating press.

NOTE

Bushings are removed from both equalizing beams the same way.

Right equalizing beam

shown.

1.

Press end bushing (1) out of equalizing beam (2). Discard bushing.

2.

Press center bushing (3) out of equalizing beam (2). Discard bushing.

END OF TASK

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

THAAD0370

Tools and Special Tools

Tool Kit, General Mechanic’s: Automotive

(WP 0183, Item 25)

Materials/Parts

Bushing, (1), (WP 0184, Item 87)

Bushing, (1), (WP 0184, Item 88)

Bushing, (2), (WP 0184, Item 89)

Cleaning Compound, Solvent (WP 0186, Item 7)

Paper, Abrasive, Garnet (Emery Cloth)

(WP 0186, Item 26)

Soap Chips (WP 0186, Item 31)

Personnel Required

MOS 63B Wheeled vehicle mechanic

References

None

Equipment Conditions

Transverse beam removed (WP 0156)

Equalizing beam removed (WP 0149)