TM-9-2320-440-13-P

TERMINAL HIGH ALTITUDE AREA DEFENSE (THAAD) CARRIER

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2010

TM-9-2320-440-13-P - Page 434 of 1616

TM 9-2320-440-13&P

0041-6

0041

OUTRIGGER CONTROLS FAIL TO OPERATE (CONTINUED)

THAAD0622

WARNING

Remove rings, wristwatches, neck chains, and any other jewelry before working

around vehicle.

Jewelry can catch on equipment and cause serious injury.

Jewelry

and tools may short across electrical circuits and cause damage to equipment or

severe burns or electrical shock to personnel.

NOTE

Due to system redundancy, the valve control signal is required from only one of the VIMs

for proper system operation.

The following steps check the valve control circuit from both

VIMs, to ensure system integrity.

Step 8.

Disconnect diode REC6. Turn engine start switch ON (

Soldier A

checks for 22 to 28 vdc between wires 1973A and 1973B at THAAD control valve

harness connector REC6, terminals 2 and 3 and a known good ground, while Soldier B

presses outrigger palm button switch (WP 0012). Note readings.

a.

If 22 to 28 vdc is not present on both wires, go to Step 12.

b.

If 22 to 28 vdc is present on both wires, perform Step 9 only.

c.

If 22 to 28 vdc is present on one wire, perform Steps 9 through 11.

Step 9.

Turn engine start switch OFF (

Check for continuity across THAAD

control valve harness wire 1973 between connector REC6, terminal 4 and connector

HvV10, terminal 2.

a.

If there is continuity, replace diode REC6 (WP 0088).

b.

If there is no continuity, repair wire 1973 (TM 9-2320-325-14&P) or

replace THAAD control valve harness (WP 0088).

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION

TM 9-2320-347-10)

TM 9-2320-347-10)