TM-9-2320-440-13-P
TERMINAL HIGH ALTITUDE AREA DEFENSE (THAAD) CARRIER
TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
AUGUST 2010
TM-9-2320-440-13-P - Page 71 of 1616
TM 9-2320-440-13&P
0011-3
0011
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
WARNING
•
Check for overhead power lines or other obstructions before attempting LHS
operation.
Serious injury or death to personnel could result from contact with
electrical power lines.
Failure to comply may result in injury or death to personnel.
•
Check ground conditions for firmness and extreme sideways inclination before
loading or unloading a MRP.
Any ground instability beneath road wheels could
create a serious situation.
Failure to comply may result in injury or death to
personnel.
•
Prior to and during any load or unload cycle, all personnel should stay clear of LHS
and MRP.
Failure to comply may result in injury or death to personnel.
8.
Turn hydraulic selector switch (6) to AUTO position.
9.
Move joystick (7) to UNLOAD position. Lift hook (8) will raise and begin to move rearwards. LHS NO
TRANSIT indicator light (9) will illuminate.
NOTE
•
To fully view lift hook relation to hook bar, it may be necessary to observe position from
outside cab.
•
LHS will only operate when transmission range selector is in N (Neutral).
10.
Continue to unload until lift hook (8) has moved to below level of MRP hook bar (2).
11.
Release joystick (7).
12.
Set transmission range selector (1) to R (Reverse) and back vehicle up to MRP, alining vehicle and lift
hook (8) as straight as possible with middle of MRP hook bar (2) until lift hook (8) contacts MRP hook
bar (2).
Be sure lift hook tip is positioned below bottom of MRP hook bar (2).
THAAD0292
Back to Top
