TM-9-2320-440-13-P
TERMINAL HIGH ALTITUDE AREA DEFENSE (THAAD) CARRIER
TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
AUGUST 2010
TM-9-2320-440-13-P - Page 72 of 1616
TM 9-2320-440-13&P
0011-4
0011
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
NOTE
LHS will only operate when transmission range selector is in N (Neutral).
13.
Set transmission range selector (1) to N (Neutral).
CAUTION
Do not use R (Reverse) to back up vehicle while hook arm is attached to MRP.
Failure to comply may result in damage to equipment.
14.
Connect vehicle static reel (14) to ground rod (16).
15.
Connect MRP static reel clamp (Refer to THAAD Launcher IETM) to ground rod (16).
16.
Move joystick (7) to LOAD position to raise lift hook (8) and engage hook bar (2).
17.
If lift hook (8) fails to engage MRP hook bar (2):
(a)
Release joystick (7).
(b)
Set transmission range selector (1) to D (Drive), release service brake pedal (3), and move vehicle
forward to clear MRP.
(c)
Move joystick (7) to UNLOAD position until lift hook (8) is below level of MRP hook bar (2).
(d)
Repeat steps (11) through (15) until lift hook (8) engages MRP hook bar (2).
18.
When correctly engaged, set transmission range selector (1) to N (Neutral) and release service brake
pedal (3).
19.
Move LHS to lift MRP slightly, install MRP bail bar lock (Refer to THAAD Launcher IETM), continue
loading MRP allowing vehicle to be pulled under MRP.
NOTE
MRP bail bar lock is stowed on MRP (Refer to THAAD Launcher IETM).
WARNING
When loading or unloading MRPs on uneven ground (side slope or downgrades up
to 5 degrees), it may be necessary to apply vehicle service brakes to prevent
vehicle rollaway.
Failure to comply may result in injury or death to personnel.
THAAD0290
Back to Top
