TM-9-2320-440-13-P
TERMINAL HIGH ALTITUDE AREA DEFENSE (THAAD) CARRIER
TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
AUGUST 2010
TM-9-2320-440-13-P - Page 74 of 1616
TM 9-2320-440-13&P
0011-6
0011
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
NOTE
If MRP is not engaged in load locks, raise MRP slightly and lower again.
MRP should set
completely and engage load locks.
28.
Inspect that both load locks (13) have engaged and MRP is completely down on vehicle.
CAUTION
Engine speed must be at idle before using hydraulic selector switch.
Failure to
comply may result in damage to equipment.
29.
Move PTO ENGAGE switch (4) to OFF position. Make sure indicator light (5) is extinguished.
30.
Turn hydraulic selector switch (6) to OFF position.
WARNING
•
When loaded with MRP, center of gravity is moved up and toward rear of vehicle.
Extreme caution must be taken when turning and ascending or descending on a
grade.
Failure to comply may result in severe injury or death to personnel.
•
Maximum side slope when loaded with a MRP is 20 percent.
Failure to comply may
result in severe injury or death to personnel or damage to equipment.
•
Do not reduce tire pressure when loaded with MRP. Highway tire pressure 60 psi
(414 kPa) front and 83 psi (572 kPa) rear, is required at all times when loaded with
MRP. Failure to comply may result in severe injury or death to personnel or damage
to equipment.
THAAD0721
Back to Top
