TM-9-2320-440-13-P
TERMINAL HIGH ALTITUDE AREA DEFENSE (THAAD) CARRIER
TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
AUGUST 2010
TM-9-2320-440-13-P - Page 77 of 1616
TM 9-2320-440-13&P
0011-9
0011
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
NOTE
Continued repetitive cycles of the LHS could cause overheating and system will fail to pick
up load. Allow hydraulic system to cool. Wait approximately 1 1/2 hours or until hydraulic
reservoir is cool. The hydraulic reservoir is cool when you can hold your hand on the
reservoir for more than 10 seconds.
5.
Start engine (
6.
Check area for sufficient operating room at front and rear of vehicle.
Check overhead clearance and
ground conditions.
7.
Apply service brake pedal (1) and set transmission range selector (2) to N (Neutral).
CAUTION
Ensure parking brake is not applied during unload sequence.
Failure to comply
may result in damage to equipment.
8.
Move PTO ENGAGE switch (3) to ON position. Indicator light (4) should illuminate.
9.
Turn hydraulic selector switch (5) to AUTO position.
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
- -
-
-
-
-
-
-
-
-
-
-
THAAD0288
TM 9-2320-347-10)
Back to Top
