TM-9-2330-202-13-P
TRAILER, CARGO, 3/4-TON, 2-WHEEL: M101A1, M101A2 AND M101A3; TRAILER, CHASSIS, 3/4-TON, 2-WHEEL: M116A1 AND M116A2; TRAILER, CHASSIS, 1-TON, 2-WHEEL: M116A3
TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
DECEMBER 2011
TM-9-2330-202-13-P - Page 179 of 552
BLACKOUT STOPLIGHT DISASSEMBLY
1.
Remove two screws (Figure 3, Item 9), lens retainer (Figure 3, Item 8), and gasket (Figure 3, Item 1). Discard
gasket (Figure 3, Item 1).
2.
Remove lamp (Figure 3, Item 2) from socket (Figure 3, Item 4) by pushing in and turning counterclockwise.
3.
Remove two screws (Figure 3, Item 3), disconnect terminal (Figure 3, Item 5), and remove socket
(Figure 3, Item 4) from housing (Figure 3, Item 6).
4.
Remove two grommets (Figure 3, Item 7) from housing (Figure 3, Item 6).
1
2
3
4
5
6
7
8
9
M116_M101_055
Figure 3.
Blackout Stoplight Disassembly.
END OF TASK
CLEANING AND INSPECTION
1.
Use detergent and water to clean housing. Dry thoroughly.
2.
Use abrasive cloth to remove corrosion.
3.
Touch up paint, refer to TM 43-0139.
4.
Inspect lens retainer for signs of moisture leakage, cracks, and warpage. Inspect lens for cracks or breaks.
Replace lens retainer if lens retainer or lens is damaged.
5.
Inspect housing for cracks and dents. Inspect connector for being electrically and mechanically good. Replace
housing if damaged.
TM 9-2330-202-13&P
0038
0038-3
Back to Top
