TM-9-2330-202-13-P

TRAILER, CARGO, 3/4-TON, 2-WHEEL: M101A1, M101A2 AND M101A3; TRAILER, CHASSIS, 3/4-TON, 2-WHEEL: M116A1 AND M116A2; TRAILER, CHASSIS, 1-TON, 2-WHEEL: M116A3

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

DECEMBER 2011

TM-9-2330-202-13-P - Page 221 of 552

FIELD MAINTENANCE

SERVICE BRAKE MAINTENANCE (M101A1 AND M116A1)

INITIAL SETUP:

Tools and Special Tools

Tool Kit, General Mechanic's

(WP

0115, Table 1, Item 1)

Materials/Parts

Three clips (WP

0089, Figure 8, Item 20)

Degreasing solvent

Materials/Parts (cont.)

(WP

0114, Table 1, Item 9)

Rag, wiping (WP

0114, Table 1, Item 24)

References

WP

0043

WP

0048

Equipment Condition

Hub and brake drum removed (WP

0055)

REMOVAL

WARNING

DO NOT handle brake shoes, brake drums, or other brake components unless area has been

properly cleaned. Dust, which can be dangerous if you breathe it, may be on these

components. Wear an approved filter mask and gloves. NEVER use compressed air or a dry

brush to clean brake components. Clean dust or mud away from brake components with

water and a wet, soft brush or cloth. Failure to comply may result in death or injury to

personnel. Seek medical attention in the event of an injury.

NOTE

It is not necessary to remove backing plate and service brake assembly from axle in order to

disassemble service brake assembly. Disassembly may be performed with service brake

assembly on axle or on work bench.

TM 9-2330-202-13&P

0046

0046-1