TM-9-2330-335-14-P
SEMITRAILER, TACTICAL, BREAKBULK/CONTAINER TRANSPORTER, 22-1/2 TON, RESET M871R, M871A1R AND M871A2R
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE MANUAL (INCLUDES REPAIR PARTS AND SPECIAL TOOLS LIST)
SEPTEMBER 2008
TM-9-2330-335-14-P - Page 252 of 640
TM 9-2330-335-14&P
0050-2
0050
REMOVAL
00050
NOTE
Step 1 applies only to the M871R and M871A1R semitrailers.
1.
Remove four self-locking nuts (Figure 1, Item 5), eight washers (Figure 1, Item 3), four screws (Figure 1, Item
4), and two brackets (Figure 1, Item 2). Discard self-locking nuts.
Figure 1.
Brackets (M871R and M871A1R Only).
050
2.
Remove two bolts (Figure 2, Item 6) and self-locking nuts (Figure 2, Item 9) from cross drive shaft (Figure 2, Item 7).
Discard self-locking nuts.
3.
Remove eight bolts (Figure 2, Item 21) and locknuts (Figure 2, Item 22) from landing leg upper bracket. Discard locknuts.
4.
Remove three bolts (Figure 2, Item 21) and locknuts (Figure 2, Item 22) from landing leg lower bracket and remove
landing leg (Figure 2, Item 1) from semitrailer. Discard locknuts.
5.
Remove hex screw (Figure 2, Item 12), self-locking nut (Figure 2, Item 9), and pin (Figure 2, Item 11) from landing gear
shoe assembly. Discard self-locking nut.
6.
Remove two hitch pins (Figure 2, Item 20), washers (Figure 2, Item 19), ties (Figure 2, Item 14), pins (Figure 2, Item 15),
front shoe assembly (Figure 2, Item 13), and rear shoe assembly (Figure 2, Item 18) from landing leg (Figure 2, Item 1).
7.
Remove two pop rivets (Figure 2, Item 17) and lanyards (Figure 2, Item 16) from landing leg (Figure 2, Item 1). Discard
pop rivets (if required).
8.
Repeat steps 3 thru 7 for remaining landing leg.
9.
Remove bolt (Figure 2, Item 6), two washers (Figure 2, Item 8), and self-locking nut (Figure 2, Item 9) from landing leg
crank (Figure 2, Item 10) and remove crank. Discard self-locking nut.
447-0201
Back to Top
