TM-9-2330-342-23-P
PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1
TECHNICAL MANUAL; FIELD MANUAL
OCTOBER 2012
TM-9-2330-342-23-P - Page 116 of 1348
3.
Perform ICE Offset Test 91.
CONDITION/INDICATION
Does test equipment pass offset test?
DECISION
Yes - Go to (Step 2 - Is continuity measured on wire 1435 between rear junction box and a known good ground?).
No - Test equipment failed offset. Contact your Supervisor.
STEP 2
Is continuity measured on wire 1435 between rear junction box and a known good ground?
WARNING
Remove all jewelry such as rings, ID tags, bracelets, etc. prior to working on or around vehicle.
Jewelry and tools can catch on equipment, contact positive electrical circuits, and cause a
direct short, severe burns, or electrical shock. Failure to comply may result in injury or death
to personnel.
1.
Remove cover from rear junction box (WP
0058).
C
L
O
S
E
O
P
E
N
COVER
REAR JUNCTION
BOX
WIRE 1435
1435
1435
1008B
1012B
1680C
1678C
1003C
1004C
Figure 2.
Rear Junction Box and Wire 1435.
2.
Connect button probe cable red lead to rear junction box assembly, terminal wire 1435.
3.
Connect button probe cable black lead to a known good ground.
4.
Perform ICE Test 91.
5.
Meter should display a reading less than 200 ohms.
TM 9-2330-342-23&P
0005
0005-2
Back to Top
