TM-9-2330-342-23-P

PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1

TECHNICAL MANUAL; FIELD MANUAL

OCTOBER 2012

TM-9-2330-342-23-P - Page 108 of 1348

TEST EQUIPMENT SETUP FOR CONTINUITY AND RESISTANCE TESTS 91 AND 92 - Continued.

5. Connect P3 end of cable to SPORT power port.

6. Attach cable grounding wire to SPORT ground stud.

7. Connect power cable to J5 ICE BOX connector and to vehicle NATO connector.

8. Connect W1 cable to J1 connector on ICE BOX and to vehicle DCA connector (if available).

9. Place ICE BOX power switch in NATO or DCA setting.

10. If performing offset procedure, short red (+) and black (-) leads together.

11. Connect red (+) and black (-) leads to the appropriate test points.

END OF TASK

Maintenance Support Device (MSD) Standard (PCMCIA) ICE Kit Setup

1. Connect button probe cable to J4 connector on ICE BOX.

ICE BOX

J4

CONNECTOR

BUTTON

PROBE

CABLE

CABLE P1

CONNECTOR

J6 CONNECTOR

J6

CONNECTOR

P1

CONNECTOR

RED

LEAD

BLACK

LEAD

Figure 23.

ICE Box Setup for Continuity and Resistance Test.

2. Connect cable P1 connector to J6 connector on ICE BOX.

CAUTION

If removing PCMCIA card, ensure PCMCIA drive is properly shutdown through Eject

Hardware icon on lower right side of desktop screen toolbar or by shutting down

Maintenance Support Device (MSD). Failure to comply may result in damage to

PCMCIA card.

3. Connect cable P2 connector to PCMCIA card.

TM 9-2330-342-23&P

0004

0004-16