TM-9-2330-342-23-P

PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1

TECHNICAL MANUAL; FIELD MANUAL

OCTOBER 2012

TM-9-2330-342-23-P - Page 579 of 1348

FIELD MAINTENANCE

AXLE NO. 2 ALIGNMENT

INITIAL SETUP:

Tools and Special Tools

Dividers, Mechanics (WP

0194, Table 1, Item 9)

Jack, Dolly Type (WP

0194, Table 1, Item 24)

Jack, Stabilizer (2) (WP

0194, Table 1, Item 25)

Trestle (Jackstand), 7 Ton (2) (WP

0194, Table 1,

Item 15)

Plumb Bob (WP

0194, Table 1, Item 31)

Socket Set, 1 in. Drive (WP

0194, Table 1, Item

37)

Socket Set, 3/4 In. (WP

0194, Table 1, Item 35)

Tape Measure, 25 ft (WP

0194, Table 1, Item 15)

Tool Kit, General Mechanic's: Automotive

(WP

0194, Table 1, Item 47)

Wrench, Impact Electric (WP

0194, Table 1, Item

51)

Wrench, Torque, Click, Ratcheting, 3/4" Drive, 600

ft-lb (WP

0194, Table 1, Item 42)

Materials/Parts

Chalk, Marking (WP

0193, Table 1, Item 12)

Tape, Adhesive (WP

0193, Table 1, Item 60)

Personnel Required

Wheeled Vehicle Mechanic (2)

References

Fig. 35 (WP

0170)

WP

0094

Equipment Condition

Wheels chocked (TM 9-2330-342-10). (WP

0190)

ALIGNMENT

NOTE

•

Both front tires must be approximately 1.0 in. (25 mm) off the floor.

•

Ensure stabilizer jacks do not interfere with a straight line between center of Axle No.

1 and ends of Axle No. 2.

1.

Using stabilizer jacks, raise and support front of trailer frame (Figure 1, Item 1).

TM 9-2330-342-23&P

0062

0062-1