TM-9-2330-342-23-P

PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1

TECHNICAL MANUAL; FIELD MANUAL

OCTOBER 2012

TM-9-2330-342-23-P - Page 818 of 1348

REMOVAL - Continued

WARNING

While changing tires or while performing tire maintenance, stay out of the trajectory as shown

by the area indicated. Failure to comply may result in injury or death to personnel.

NOTE

Trajectory area as shown applies to all wheel/tire assemblies.

1.

Take tire pressure reading on tire/wheel to be changed and compare to Table 1. If tire is underinflated or

overinflated, or there is obvious damage or suspected damage to wheel or tire, completely deflate tire before

removing from trailer. Refer to TM 9-2330-342-10 (WP

0190).

1

TRAJECTORY

2

3

4

5

JACKSTAND

HYDRAULIC

JACK

Figure 1.

Wheel/Tire Removal.

2.

Loosen ten lugnuts (Figure 1, Item 1), but do not remove.

3.

Position hydraulic jack under axle (Figure 1, Item 5).

4.

Using jack, raise axle (Figure 1, Item 5) approximately 2.0 in. (50.8 mm) until tire (Figure 1, Item 2) just clears

ground; position jackstand under axle (Figure 1, Item 5).

5.

Lower jack until axle (Figure 1, Item 5) rests on jackstand.

6.

Remove ten lugnuts (Figure 1, Item 1) from studs (Figure 1, Item 3).

TM 9-2330-342-23&P

0094

0094-2