TM-9-2330-356-14
SEMITRAILER, TANK: 5000 GALLON, BULK HAUL, SELF LOAD/UNLOAD M967 AND M967A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, AUTOMOTIVE M969 AND M969A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, UNDER/OVERWING AIRCRAFT M970 AND M970A1
TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL
OCTOBER 1990
TM-9-2330-356-14 - Page 72 of 528
TM 9-2330-356-14
c.
Nonfiltered Dispensing (M969 and M969A1).
Fuel
which does not require filtering is routed directly from the
pump to the hose reels, bypassing the filter/separator
(fig. 2-28). Use the following procedure:
(1) Review instructions in paragraph 2-8.
(2) Ensure that all valves are closed.
NOTE
If two vehicles are being serviced, make sure
they are both grounded using separate static
reels. M969 and M969A1 are equipped with
two static reels (figs. 2-11 and 2-14).
(3) Unreel static reel cable (fig. 2-11), and
connect it to a suitable ground and to automotive
unit /container. Remove fire extinguishers and bring them
to the point of operation.
(4) Start engine (para 2-10c). When engine, is
warm, adjust throttle to idle speed (1000-1200 rpm).
(5) Put valve E (fig. 2-11) in UNLOAD position.
(6) Open valves A (para 2-11f), F, H, and K.
(7) Reset meter (fig. 2-14) to zero by pushing
reset knob and turning clockwise. Open either valve P or
R.
(8) Adjust engine throttle for desired flow rate
(table 2-2).
Figure 2-28. M969 and M969A1, Nonfiltered Dispensing Flow Diagram.
2-30
Back to Top
