TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 713 of 1364

TM 9-2350-238-20-1

Failure to remove or disconnect batteries before removing or installing any electrical

wiring harness or lead may result in injury or damaged equipment.

1

Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,

clips, ground screws, etc. Remove only the hardware which secures the wiring harness or lead

which is

2

Remove

3

Tag and

4

Tag and

5

Remove

being removed.

two screws (1) and circuit

disconnect plug connector

disconnect plug connector

hull disconnect to slip ring

breaker (2) from bulkhead.

(3) from slip ring.

(4) from hull disconnect.

lead and circuit breaker (5) from hull.

1

2

NOTE

Two screws and four washers are

supplied with circuit breaker; use care

not to lose them. If lost or damaged,

order a new circuit breaker.

Remove two screws (1), four washers (2),

and two cable terminals (3) from circuit

breaker (4).

For disassembly of wiring harness plug

connectors, refer to general maintenance,

page 2-371.

2-687