TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 707 of 1364

TM 9-2350-238-20-1

2

Disconnect shell connector (1) from fuel level sending unit.

3

Disconnect plug connector (2) from bulkhead disconnect.

4

Disconnect magnetic clutch connector from plug connector (3).

5

Disconnect cable terminal (4)

6

Remove bulkhead disconnect

For disassembly of wiring harness

1

Inspect for broken, damaged,

from ground.

to magnetic clutch branched wiring harness (5) from hull well.

plug connectors, refer to general maintenance, page 2-371.

or missing parts.

2

If damaged or missing, replace marker bands. Etch or stamp lead number on new band.

3

For repair of shell connector and cable terminal, refer to general maintenance, page 2-371.

4

Electrical wire is a manufactured item, refer to appendix D.

5

Repair is by replacement of authorized parts (TM 9-2350-238-24P-1).

For reassembly of wiring harness plug connectors, refer to general maintenance, page 2-371.

1

Install bulkhead disconnect to magnetic clutch branched wiring harness (5) to hull well.

2

Connect cable terminal (4) to ground.

3

Connect magnetic clutch connector to plug connector (3).

4

Connect plug connector (2) to bulkhead disconnect.

5

Connect shell connector (1) to fuel level sending unit.

6

Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,

clips, ground screws, etc. During installation, make sure the wiring harness or lead is secure

and all hardware is tight.

2-681