TM-9-2350-238-20-1
HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL
MAY 1994
TM-9-2350-238-20-1 - Page 725 of 1364
TM 9-2350-238-20-1
REMOVAL
1
2
3
4
5
6
Failure to remove or disconnect bat-
teries before removing or installing
any electrical wiring harness or lead
may result in injury or damaged
equipment.
Wiring harnesses and leads are secured to
the hull and components with loop clamps,
straps, clips, ground screws, etc. Remove
only the hardware which secures the
wiring harness or lead being removed.
Tag and disconnect three cable terminals
(1) from three generator control circuits,
terminals A, B, and D.
Tag and disconnect two shell connectors
(2) from circuit breaker.
Tag and disconnect shell connector (3)
from line connection.
Remove four screws (4) and disconnect
receptacle connector (5) from bracket
receptacle.
Remove generator control circuits to
bracket disconnect branched wiring
harness (6) from hull.
For disassembly of wiring harness receptacle
connector, refer to general
2-371.
maintenance, page
1
Inspect for broken, damaged, or missing
parts.
2
If damaged or missing, replace marker
bands. Etch or stamp lead number on
new band.
3
4
5
For repair of cable terminals and shell
connectors, refer to general maintenance,
page 2-371.
Electrical wire and insulation sleeving are
manufactured items, refer to appendix D.
Repair is by replacement of authorized
parts (TM 9-2350-238-24P-1).
For reassembly of wiring harness receptacle
connector, refer to general maintenance, page
2-371.
1
2
3
4
5
6
Install generator control circuits to bracket
disconnect branched wiring harness (6) to
hull.
Connect receptacle connector (5) to
bracket receptacle and install four screws
(4).
Untag and connect shell connector (3) to
line connection.
Untag and connect two shell connectors
(2) to circuit breaker.
Untag and connect three cable terminals
(1) to three generator control circuits,
terminals A, B, and D.
Wiring harnesses and leads are secured to
the hull and components with loop clamps,
straps, clips, ground screws, etc. During
installation, make sure the wiring harness
or lead is secure and all hardware is tight.
2-699
Back to Top
