TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 731 of 1364

TM 9-2350-238-20-1

INSTALLATION

1

Install disconnect to forward air cleaner

4

Close air cleaner blower motor access

blower motor electrical lead (4) to hull

door (1).

through driver’s compartment.

5

Wiring harnesses and leads are secured to

2

Untag and connect shell connector (3) to

the hull and components with loop clamps,

line connection disconnect.

straps, clips, ground screws, etc. During

installation, make sure the wiring harness

3

Untag and connect shell connector (2) to

or lead is secure and all hardware is tight.

forward air cleaner centrifugal fan.

2-109. MAINTENANCE OF FUEL PURGE-AND-PRIME SWITCH TO SOLENOID

ELECTRICAL LEAD (ENGINE MODEL 7083-7395).

This task covers:

a.

Removal

b..

Inspection/Repair

c.

Installation

INITIAL SETUP

Materials/Parts

Electrical wire (figure D-2, appx D)

References

TM 9-2350-238-24P-1

Equipment Conditions

2-640 Batteries disconnected

2-952 Driver’s seat removed

General Safety Instructions

Failure to remove or disconnect batteries before removing or installing any electrical

wiring harness or lead may result in injury or damaged equipment.

2-705