TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 733 of 1364

TM 9-2350-238-20-1

1

Install fuel purge-and-prime switch to solenoid electrical lead (1) in hull through driver’s

compartment.

2

Connect shell connector (2) to pump.

3

Connect shell connector (3) to prime switch.

4

Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,

clips, ground screws, etc.

During installation, make sure the wiring harness or lead is secure

and all hardware is tight.

2-110. MAINTENANCE OF BULKHEAD DISCONNECT TO TRAILER RECEPTACLE

DISCONNECT, AFT BLOWER MOTOR, AND TAILLIGHTS BRANCHED WIRING

HARNESS.

This task covers:

a.

Removal

d.

Reassembly

b.

Disassembly

e.

Installation

c.

Inspection/Repair

INITIAL SETUP

Materials/Parts

Electrical wire (figure D-2, appx D)

Rod (figure D-24, appx D)

References

TM 9-2350-238-20-2

TM 9-2350-238-24P-1

Equipment Conditions

2-640 Batteries disconnected

2-918 Battery access door assembly open and all batteries removed

2-640 Battery compartment tray removed

Accessory stowage box removed (TM 9-2350-238-20-2)

General Safety Instructions

Failure to remove or disconnect batteries before removing or installing any

electrical wiring harness or lead may result in injury or damaged equipment.

2-707