TM-9-2350-238-20-1
HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL
MAY 1994
TM-9-2350-238-20-1 - Page 737 of 1364
TM 9-2350-238-20-1
1
2
3
4
5
6
Install bulkhead disconnect to trailer receptacle disconnect, aft blower motor, and taillights
branched wiring harness (1) in hull.
Untag and connect five shell connectors (2) to trailer receptacle disconnect.
Untag and connect three shell connectors (3) to left taillight.
Untag and connect two shell connectors (4) to right taillight.
Connect plug connector (5) to bulkhead disconnect.
Untag and connect shell connector (6) to air cleaner blower motor.
7
Untag and connect two shell connectors (7) to line connections.
8
Install gasket (8) on receptacle connector (9).
9
Install receptacle connector (9) with gasket (8), four washers (10),
capscrews (11) on bulkhead.
10
Connect plug connector (12) to receptacle connector (9).
and four socket head
11
Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,
clips, ground screws, etc. During installation, make sure the wiring harness or lead is secure
and all hardware is tight.
2-111. MAINTENANCE OF LIGHTING SWITCH TO VEHICLE ACCESSORIES AND
DISCONNECT BRANCHED WIRING HARNESS.
This task covers:
a.
Removal
d.
Reassembly
b.
Disassembly
e.
Installation
c.
Inspection/Repair
INITIAL SETUP
Materials/Parts
General Safety Instructions
Electrical wire (figure D-2, appx D)
Rod (figure D-24, appx D)
WARNING
References
Failure to remove or disconnect
TM 9-2350-238-24P-1
batteries before removing or installing
any electrical wiring harness or lead
Equipment Conditions
may result in injury or damaged
2-640 Batteries disconnected
equipment.
2-952 Driver’s seat removed
2-928 Driver’s compartment forward
cowl removed
2-928 Driver’s compartment aft cowl
removed
2-711
Back to Top
