TM-9-2350-238-20-1
HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL
MAY 1994
TM-9-2350-238-20-1 - Page 741 of 1364
TM 9-2350-238-20-1
5
6
7
8
Untag and connect plug connector (5) to
pressure switch.
Untag and connect plug connector (6) to
right headlight.
Untag and connect plug connector (7) to
dimmer switch.
Connect 23 shell connectors at the
following points:
a.
Untag and connect two shell
connectors (8) to stoplight switch.
b.
Untag and connect shell connector (9)
to suspension lockout system indicator
light.
e.
Untag and connect six shell
connectors (12) to left headlight.
f.
Untag and connect shell connector
(13) to forward air cleaner.
g.
Untag and connect two shell
connectors (14) to horn switch.
h.
Untag and connect seven shell
connectors (15) to line connection.
9
Wiring harnesses and leads are secured to
the hull and components with loop clamps,
straps, clips, ground screws, etc. During
installation, make sure the wiring harness
or lead is secure and all hardware is tight.
c.
Untag and connect three shell
connectors (10) to infrared and
blackout drive selector switch.
d.
Untag and connect shell connector
(11) to panel light.
2-112. MAINTENANCE OF BATTERY TO BULKHEAD DISCONNECT CABLE
ASSEMBLY.
This task covers:
a.
Removal
d.
Reassembly
b.
Disassembly
e.
Installation
c.
Inspection/Repair
INITIAL SETUP
Materials/Parts
General Safety Instructions
Electrical wire (figure D-2, appx D)
Gasket
Insulation sleeving (figure D-1, appx D)
Failure to remove or disconnect
References
batteries before removing or installing
TM 9-2350-238-24P-1
any electrical wiring harness or lead
may result in injury or damaged
Equipment Conditions
equipment.
2-918 Hull access cover removed
2-640 Battery access cover open and all
batteries removed
2-715
Back to Top
