TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

  TM-9-2350-238-20-1 - Page 749 of 1364

TM 9-2350-238-20-1
10
Install electrical lead 515 through pin hole D in electrical insert (7) and rubber bushing (6).
11
Install electrical lead 514 through pin hole E in electrical insert (7) and rubber bushing (6).
12
Install electrical lead 20 through pin hole F in electrical insert (7) and rubber bushing (6).
13
Check continuity of each electrical lead in disconnect to headlamp wiring harness per MIL-STD-
202, method 303.
14
Install insulation tape (11) on electrical wires (9) where insulation was stripped back. Make 0.5
in. (1.27 cm) overlapping turns to ensure that leads are adequately covered.
1
2
3
4
5
NOTE
Procedures to install disconnect to headlamp wiring harness are written for the right
side, but apply to both the right and left sides.
Install right disconnect to headlamp wiring harness (1) to hull.
Slide headless connectors base assembly (2) into hull.
Connect cable terminal (3) to ground on right disconnect to headlamp wiring harness (1).
Untag and connect six shell connectors (4) to line connections on right disconnect to headlamp
wiring harness (1).
Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,
clips, ground screws, etc. During installation, make sure the wiring harness or lead is secure
and all hardware is tight.
2-723


Back to Top