TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 752 of 1364

TM 9-2350-238-20-1

2-116. MAINTENANCE OF FUEL PURGE-AND-PRIME SWITCH TO SOLENOID

ELECTRICAL LEAD (ENGINE MODEL 7083-7398).

This task covers:

a.

Removal

b.

Inspection/Repair

c.

Installation

INITIAL SETUP

Materials/Parts

General Safety Instructions

Electrical wire (figure D-2, appx D)

References

TM 9-2350-238-24P-1

Failure to remove or disconnect

batteries before removing or installing

Equipment Conditions

any electrical wiring harness or lead

2-840 Batteries disconnected

may result in injury or damaged

2-952 Driver’s seat removed

equipment.

Failure to remove or disconnect batteries before removing or installing any electrical

wiring harness or lead may result in injury or damaged equipment.

1

Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,

clips, ground screws, etc. Remove only the hardware which secures the wiring harness or lead

being removed.

2

Disconnect shell connector (1) from prime switch.

2-726