TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 747 of 1364

TM 9-2350-238-20-1

Failure to remove or disconnect

batteries before removing or installing

any electrical wiring harness or lead

may result in injury or damaged

equipment.

NOTE

Procedures to remove disconnect to

headlamp wiring harness are written

for the right side, but apply to both the

right and left sides.

1

Wiring harnesses and leads are secured to

the hull and components with loop clamps,

straps, clips, ground screws, etc. Remove

2

3

4

5

only the hardware which secures the

wiring harness or lead being removed.

Tag and disconnect six shell connectors

(1) from line connection on right discon-

nect to headlamp wiring harness (2).

Disconnect cable terminal (3) from ground

on right disconnect to headlamp wiring

harness (2).

Remove headless connectors base

assembly (4) from hull.

Remove right disconnect to headlamp

wiring harness (2) from hull.

DISASSEMBLY

1

Strip insulation (1) back from headless

connectors base assembly (2).

NOTE

The following steps are written for the

removal of one electrical lead, but

apply to all electrical leads.

2

Remove electrical wire (3) and electrical

contact (4) from rubber bushing (5) and

electrical insert (6).

3

Remove electrical contact (4) from

electrical wire (3).

5

Remove electrical insert (6) from threaded

base (8).

6

Remove rubber bushing (5) from threaded

base (8).

7

Remove nonmetallic seal (9) from

threaded base (8).

8

Remove two machine screws (10), two

Iockwashers (11), and spring tension clip

(12) from threaded base (8).

4

Remove rod (7) from electrical insert (6).

2-721