TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

  TM-9-2350-238-20-1 - Page 744 of 1364

TM 9-2350-238-20-1
2-113. MAINTENANCE OF BULKHEAD TO BULKHEAD STARTER CIRCUIT
BRANCHED WIRING HARNESS.
This task covers: a.
Removal
c.
Inspection/Repair
e.
Installation
b.
Disassembly
d.
Reassembly
INITIAL SETUP
Materials/Parts
Electrical wire (figure D-2, appx D)
Electrical wire (figure D-2, appx D)
Gasket
References
TM 9-2350-238-24P-1
Equipment Conditions
2-840 Batteries disconnected
2-952
Driver's seat removed
2-928 Driver's compartment forward
2-928 Driver's compartment aft cowl
removed
General Safety Instructions
Failure to remove or disconnect
batteries before removing or installing
any electrical wiring harness or lead
may result in injury or damaged
cowl removed
equipment.
REMOVAL
Failure to remove or disconnect batteries before removing or installing any electrical
wiring harness or lead may result in injury or damaged equipment.
1
Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,
clips, ground screws, etc.
Remove only the hardware which secures the wiring harness or lead
being removed.
2-718


Back to Top