TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 755 of 1364

TM 9-2350-238-20-1

1

Inspect for broken, damaged, or missing

parts.

2

If damaged or missing, replace marker

bands. Etch or stamp lead number on

new band.

3

For repair of shell connectors and cable

terminals, refer to page 2-371.

1

2

3

4

5

6

7

Install warning light low coolant detector to

bulkhead disconnect branched wiring

harness (1) on powerplant.

Untag and connect cable terminal (2) to

ground.

Untag and connect three cable terminals

(3) to aeration detector.

Install aeration detector cover (4) and two

screws (5).

Untag and connect shell connector (6) to

diode assembly and transmission

temperature warning switch.

Untag and connect two shell connectors

(7) to line disconnects to warning light.

Wiring harnesses and leads are secured

to the engine with loop clamps, straps,

ground screws, etc. During installation,

make sure the wiring harness or lead is

secure and all hardware is tight.

4

Electrical wire is a manufactured item,

refer to appendix D.

5

Repair is by replacement of authorized

parts (TM 9-2350-238-24P-1).

2-729